CAB40710

10 foot 10 pin Male (RM) to 6 pin Female (HR),
7 conductor wire (P/N 380-400-0007)

10 pin male

Wire for 10 pin male

Signal

Wire for
6 pin female

6 pin
female
1 White Center NTSC White Center 5
2 White Shield (see 9) Ground White Shield 4
3 Yellow Center Y Yellow Center 1
4 Yellow Shield Ground Yellow & Black Shields 3
5 No conn. - - -
6 No conn. - - -
7 Black Center C Black Center 2
8 Black Shield (see 9) - - -
9 **Jumper to pin 8 & 2 - - -
10 *Red Shield +12V   *Red Shield 6

* Heat shrink to prevent shorting to other wires with 1/8" heat shrink.
** Use #18 bus wire or equivalent to connect pins 2, 8 and 9.
Place 1" clear heat shrink near 10 pin end for label.
See diagram for other heat shrink instructions.

View from solder side:

10 pinmalejump.gif (4052 bytes)
10 pin male
P/N 150-007-1010

6pinmalesmall.gif (1991 bytes)
6 pin female
P/N 150-003-0060

cab40710.gif (4382 bytes)
Assembly diagram

© 2001 MicroImage Video Systems, a division of World Video Sales Co., Inc.
All rights reserved.  Specifications subject to change without notice. 04/10/12
Problems with this site? contact the  webmaster@mivs.com  
w w w .  m i v s . c o m