buy Sildenafil without prescription Zyban without prescription Buy Propranolol Buy viagra super active Aciphex Bactroban no prescription Buy Citalopram buy Pepcid online buy Bactroban Lasix without prescription buy Premarin online Soma

Standard Color Bars

Color Bar Display

colorbars-s420t

The photo above shows the standard SMPTE style color bars. These color bars are produced by several MicroImage Video Systems’ products although some products only produce full field color bars. See the test signal generator section for additional information.

Note the order of Gray, Yellow, Cyan, Green, Magenta, Red, and Blue from left to right. If any of these colors are reversed on the screen, check for switched RGB cables. Note that on many monitors, not all colors will look 100% correct, usually yellow will be a different shade (although this is more common with older CRT monitors).

If the colors are incorrect when using composite or S-Video. then adjust the HUE and COLOR controls on the monitor for proper colors. If your monitor has a “blue only” switch or you can turn off the red and green channels, refer to your monitor manual on how to accurately set chroma (color) and phase (hue) with this feature.

The -I and Q are colors, just off vector from blue (-I is toward green) and (Q is toward red). These are typically used for factory measurements and may appear different in RGB vs composite/S-Video (YC). RGB signals are not capable of rendering these signals accurately and they would require one of or more of the color channels to go into a negative value.

The pluge signals, -4, 0, and +4, are used to set brightness on video monitors. When adjusted properly, only the +4 bar should be barely visible while the -4 and 0 both appear black.