|
| Our selection of
board level products are derived from our standard products. They are basically the same
but without the case. Custom and semi-custom versions are available. Many boards have a
standard connection but many different configurations are available. Please contact the
Engineering Department at MicroImage Video Systems
to obtain additional technical information. Below is a small selection of our board level
products. |
|
 
Base model # CBG400BL1The MicroImage Video Systems RGB color bar generator board is deigned to be
embedded in a product as a test signal source to confirm proper equipment operation.
- SMPTE style color bar display
- Produces RGB and Sync outputs
- Optional sync on green (jumper selectable)
- RS170 (NTSC) 60Hz Timing
- +5VDC power
- Only 2" x 2" x 0.5"
- Some customization available - contact factory
Additional
Information |
|
|
Base Model # BL-PXD510E-01
This board will take two video sources and present them side by side, top bottom or
overlay them on a single video signal. This unit uses extensive digital signal processing
to achieve a high degree of performance and maintain signal quality. ALl functions are
described in the packaged version - the model
PXD310E
- Available for composite video and
S-Video. Will work with B&W signals. Optional RGB output.
- Can be controlled by RS-232 or from
the front panel switches (if included).
- Video sources do NOT need genlock
capability. Works with almost any standard video source.
- NTSC and PAL compatible, all inputs
and outputs must be the same.
- Digital Signal Processing provides
repeatable performance and signal quality.
- +9 to +20VDC power.
- Available with standard connectors or
header connectors.
- Can be customized for non-standard
applications through software and programmable logic changes.
|
|
 The Video Encoder converts RS170 compatible
RGB or RGBS signals to composite NTSC and S-Video signals.
- Accepts RGB with sync on green or
RGBS input
- Produces NTSC Composite and S-Video
- RS170 timing
- +9 to +20VDC power
- Available with standard connectors or
header connectors
For more information, see the
packaged version ENC400A datasheet |
|
 Video
Distribution Amplifiers are used to route a video signal to several
pieces of equipment, especially if longer cable runs are involved.
- Available for B&W, composite
video, S-Video and RGB and Sync signals
- 1 input - 6 or 8 outputs for
composite and B&W
- 1 input - 6 output for S-Video
- 1 input - 3 output by 4 channels for
RGB/RGBS
For more information, see the
packaged version VDA datasheet |
|
 Video
Distribution Amplifiers are used to route a video signal to several
pieces of equipment, especially if longer cable runs are involved.
- Available for B&W, composite
video or S-Video signals
- NTSC (RS170) or PAL (CCIR) compatible
- 4 inputs and 1 output
- RS-232 and logic level (several
modes) remote capability
- Selectable vertical or no
synchronization switching
- +9 to +20VDC power
For more information, see the
packaged version Active Switch
Datasheet |
